C8051F120 Datasheet, PDF (250/356 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F120/1/2/3/4/5/6/7
C8051F130/1/2/3
R/W
P0.7
Bit7
R/W
P0.6
Bit6
R/W
P0.5
Bit5
R/W
P0.4
Bit4
R/W
P0.3
Bit3
R/W
P0.2
Bit2
R/W
P0.1
Bit1
R/W
Reset Value
P0.0 11111111
Bit0
Bit
Addressable
SFR Address: 0x80
SFR Page: All Pages
Bits7-0:
P0.[7:0]: Port0 Output Latch Bits.
(Write - Output appears on I/O pins per XBR0, XBR1, and XBR2 Registers)
0: Logic Low Output.
1: Logic High Output (open if corresponding P0MDOUT.n bit = 0).
(Read - Regardless of XBR0, XBR1, and XBR2 Register settings).
0: P0.n pin is logic low.
1: P0.n pin is logic high.
Note: P0.7 (/WR), P0.6 (/RD), and P0.5 (ALE) can be driven by the External Data Memory
Interface. See Section “17. External Data Memory Interface and On-Chip XRAM” on
page 221 for more information. See also Figure 18.9 for information about configuring the
Crossbar for External Memory accesses.
Figure 18.10. P0: Port0 Data Register
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
SFR Address: 0xA4
SFR Page: F
Bits7-0: P0MDOUT.[7:0]: Port0 Output Mode Bits.
0: Port Pin output mode is configured as Open-Drain.
1: Port Pin output mode is configured as Push-Pull.
Note:
SDA, SCL, and RX0 (when UART0 is in Mode 0) and RX1 (when UART1 is in Mode 0) are
always configured as Open-Drain when they appear on Port pins.
Figure 18.11. P0MDOUT: Port0 Output Mode Register
252
Rev. 1.3