M16C29 Datasheet, PDF (251/499 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M16C/Tiny SERIES

M16C/29 Group
15. A/D Converter
Timer B2 special mode register ⁽¹⁾
b7 b6 b5 b4 b3 b2 b1 b0
00
Symbol
TB2SC
Address
039E16
After Reset
X00000002
Bit Symbol
Bit Name
Function
RW
PWCON Timer B2 reload timing 0: Timer B2 underflow
switch bit ⁽²⁾
1: Timer A output at odd-numbered
RW
IVPCR1 ^{Three-phase output port 0: Three-phase output forcible cutoff}
SD control bit 1
by SD pin input (high impedance)
(3, 4, 7)
disabled
RW
1: Three-phase output forcible cutoff
by SD pin input (high impedance)
enabled
TB0EN ^{Timer B0 operation mode 0: Other than A/D trigger mode}
select bit
1: A/D trigger mode ⁽⁵⁾
RW
TB1EN ^{Timer B1 operation mode 0: Other than A/D trigger mode}
select bit
1: A/D trigger mode ⁽⁵⁾
RW
TB2SEL Trigger select bit ⁽⁶⁾
0: TB2 interrupt
1: Underflow of TB2 interrupt
RW
generation frequency setting counter [ICTB2]
(b6-b5) ^{Reserved bits}
Set to 0
RW
Nothing is assigned. If necessary, set to 0.
(b7)
When read, its content is 0
NOTES:
1. Write to this register after setting the PRC1 bit in the PRCR register to 1 (write enabled).
2. If the INV11 bit is 0 (three-phase mode 0) or the INV06 bit is 1 (triangular wave modulation mode), set this bit to 0 (timer
B2 underflow).
3. When setting the IVPCR1 bit to 1 (three-phase output forcible cutoff by SD pin input enabled), Set the PD85 bit to 0 (= input
mode).
4. Related pins are U(P80), U(P81), V(P72), V(P73), W(P74), W(P75). When a high-level ("H") signal is applied to the SD pin
and set the IVPCR1 bit to 0 after forcible cutoff, pins U, U, V, V, W, and W are exit from the high-impedance state. If a low-
level (“L”) signal is applied to the SD pin, three-phase motor control timer output will be disabled (INV03=0). At this time,
when the IVPCR1 bit is 0, pins U, U, V, V, W, and W become programmable I/O ports. When the IVPCR1 bit is set to 1,
pins U, U, V, V, W, and W are placed in a high-impedance state regardless of which function of those pins is used.
5. When this bit is used in delayed trigger mode 0, set bits TB0EN and TB1EN to 1 (A/D trigger mode).
6. When setting the TB2SEL bit to 1 (underflow of TB2 interrupt generation frequency setting counter[ICTB2]), set the INV02
bit to 1 (three-phase motor control timer function).
Figure 15.5 TB2SC Register
Rev. 1.12 Mar.30, 2007 ^{page 227} of 458
REJ09B0101-0112