PIC18F6585 Datasheet, PDF (154/496 Pages) Microchip Technology – 64/68/80-Pin High-Performance, 64-Kbyte Enhanced Flash Microcontrollers with ECAN Module

PIC18F6585/8585/6680/8680
10.10 Parallel Slave Port (PSP)
PORTD also operates as an 8-bit wide Parallel Slave
Port, or microprocessor port, when control bit
PSPMODE (TRISE<4>) is set. It is asynchronously
readable and writable by the external world through RD
control input pin, RE0/RD/AD8 and WR control input
pin, RE1/WR/AD9.
Note:
For PIC18F8X8X devices, the Parallel
Slave Port is available only in
Microcontroller mode.
The PSP can directly interface to an 8-bit micro-
processor data bus. The external microprocessor can
read or write the PORTD latch as an 8-bit latch. Setting
bit PSPMODE enables port pin RE0/RD/AD8 to be the
RD input, RE1/WR/AD9 to be the WR input and
RE2/CS/AD10 to be the CS (chip select) input. For this
functionality, the corresponding data direction bits of
the TRISE register (TRISE<2:0>) must be configured
as inputs (set). The A/D port configuration bits
PCFG2:PCFG0 (ADCON1<2:0>) must be set, which
will configure pins RE2:RE0 as digital I/O.
A write to the PSP occurs when both the CS and WR
lines are first detected low. A read from the PSP occurs
when both the CS and RD lines are first detected low.
The PORTE I/O pins become control inputs for
the microprocessor port when bit PSPMODE
(PSPCON<4>) is set. In this mode, the user must make
sure that the TRISE<2:0> bits are set (pins are config-
ured as digital inputs) and the ADCON1 is configured
for digital I/O. In this mode, the input buffers are TTL.
FIGURE 10-28:
PORTD AND PORTE
BLOCK DIAGRAM
(PARALLEL SLAVE PORT)
Data Bus
DQ
WR LATD
or
CK
PORTD
Data Latch
Q
D
RD PORTD
ENEN
TRIS Latch
RDx
pin
TTL
RD LATD
One bit of PORTD
Set Interrupt Flag
PSPIF (PIR1<7>)
Read
TTL
RD
Chip Select
TTL
CS
Write
TTL
WR
Note: I/O pin has protection diodes to VDD and VSS.
DS30491C-page 152
 2004 Microchip Technology Inc.