TLK3132 Datasheet, PDF (61/103 Pages) Texas Instruments – 2-Channel Multi-Rate Transceiver

www.ti.com
TLK3132
2-Channel Multi-Rate Transceiver
SLLS956 – DECEMBER 2008
• If Single Ended REFCLK used – Write 2’b10 to 37120.11:10
• If Differential REFCLK used – Write 2’b11 to 37120.11:10
– Select SERDES RX Reference Clock Input:
• If Single Ended REFCLK used – Write 2’b10 to 37120.9:8
• If Differential REFCLK used – Write 2’b11 to 37120.9:8
– Ensure a legal reference clock operation frequency is selected based on Appendix A, and provision
control settings accordingly. It is also possible to use the Jitter Cleaner during these tests, and the
user should consult Appendix A for further Jitter Cleaner provisioning details.
– Issue Datapath Reset:
• Write 1’b1 to 16.11
• Write 1’b0, then 1'b1, followed by 1'b0 to 37636.14
– GPO1 contains a real time output that when high indicates if the input PRBS pattern on TD×1/RD×1
is errored.
– GPO0 contains a real time output that when high indicates if the input PRBS pattern on TD×0/RD×0
is errored.
• SERDES Macro 2⁷-1/2²³-1 PRBS Register Based Testing
– Reset Device:
• Issue a hard or soft reset (RST_N asserted -or- Write 1 to 0.15)
– Select single ended or differential REFCLK input:
• If Single Ended REFCLK used – Write 2’b01 to 37120.15:14
• If Differential REFCLK used – Write 2’b00 to 37120.15:14
– Select SERDES TX Reference Clock Input:
• If Single Ended REFCLK used – Write 2’b10 to 37120.11:10
• If Differential REFCLK used – Write 2’b11 to 37120.11:10
– Select SERDES RX Reference Clock Input:
• If Single Ended REFCLK used – Write 2’b10 to 37120.9:8
• If Differential REFCLK used – Write 2’b11 to 37120.9:8
– Ensure a legal reference clock operation frequency is selected based on Appendix A, and provision
control settings accordingly. It is also possible to use the Jitter Cleaner during these tests, and the
user should consult Appendix A for further Jitter Cleaner provisioning details.
– PRBS Selection:
• For PRBS 2⁷-1-
– Write 2’b10 36881.1:0.
– Write 2’b10 36882.1:0.
• For PRBS 2²³-1-
– Write 2’b11 36881.1:0.
– Write 2’b11 36882.1:0.
– Enable PRBS Generation:
• Write 1’b1 to 36881.2
• Write 1’b1 to 36874.1
• Write 1’b1 to 36876.1
– Enable PRBS Verification:
• Write 1’b1 to 36882.3
• Write 1’b1 to 36866.1
• Write 1’b1 to 36868.1
– Clear Counters:
• Read 38144.7:0 and discard the value.
• Read 38145.7:0 and discard the value.
Submit Documentation Feedback
Device Reset Requirements/Procedure
61