TLK3132 Datasheet, PDF (60/103 Pages) Texas Instruments – 2-Channel Multi-Rate Transceiver

TLK3132
2-Channel Multi-Rate Transceiver
SLLS956 – DECEMBER 2008
www.ti.com
3.3 PRBS Test Generation and Verification Procedures
Use one of the following procedures to generate and verify the respective PRBS test patterns. It is
assumed that an appropriate external cable has been connected between serial outputs and serial inputs.
No functional parallel side connections are necessary.
• 1000Base-X 2⁷-1 PRBS Register Based Testing
– Device Pin Setting(s):
• Ensure CODE primary input pin is low.
– Reset Device:
• Issue a hard or soft reset (RST_N asserted -or- Write 1 to 0.15)
– Select single ended or differential REFCLK input:
• If Single Ended REFCLK used – Write 2’b01 to 37120.15:14
• If Differential REFCLK used – Write 2’b00 to 37120.15:14
– Select SERDES TX Reference Clock Input:
• If Single Ended REFCLK used – Write 2’b10 to 37120.11:10
• If Differential REFCLK used – Write 2’b11 to 37120.11:10
– Select SERDES RX Reference Clock Input:
• If Single Ended REFCLK used – Write 2’b10 to 37120.9:8
• If Differential REFCLK used – Write 2’b11 to 37120.9:8
– Ensure a legal reference clock operation frequency is selected based on Appendix A, and provision
control settings accordingly. It is also possible to use the Jitter Cleaner during these tests, and the
user should consult Appendix A for further Jitter Cleaner provisioning details.
– Issue Datapath Reset:
• Write 1’b1 to 16.11
• Write 1’b0, then 1’b1, followed by 1’b0 to 37636.14.
– Enable PRBS Generator (On Channel Desired):
• Write 1’b1 to 16.6
– Enable Test Pattern Verification:
• Write 1’b1 to 16.7
– Clear Counters:
• Read 29.15:0 and discard the value.
– The pattern verification is now in progress.
– Verify Error Free Operation (as many times as desired during the duration of the test period):
• Read 29.15:0, and verify 16’h0000 is read to confirm error free operation.
– GPO1 contains a real time output that when high indicates if the input PRBS pattern on TD×1/RD×1
is errored.
– GPO0 contains a real time output that when high indicates if the input PRBS pattern on TD×0/RD×0
is errored.
• 2⁷-1 PRBS Pin Based Testing
– Device Pin Setting(s):
• Ensure PRBS_EN primary input pin is high.
• PRBS Selection:
– For PRBS 2⁷-1 will be selected
– Reset Device:
• Issue a hard or soft reset (RST_N asserted -or- Write 1 to 0.15)
– Select single ended or differential REFCLK input:
• If Single Ended REFCLK used – Write 2’b01 to 37120.15:14
• If Differential REFCLK used – Write 2’b00 to 37120.15:14
– Select SERDES TX Reference Clock Input:
60
Device Reset Requirements/Procedure
Submit Documentation Feedback