PIC18CXX2_13 Datasheet, PDF (165/304 Pages) Microchip Technology – High Performance Microcontrollers with 10-bit A/D

PIC18CXX2
16.0 COMPATIBLE 10-BIT ANALOG-
TO-DIGITAL CONVERTER (A/D)
MODULE
The analog-to-digital (A/D) converter module has five
inputs for the PIC18C2x2 devices and eight for the
PIC18C4x2 devices. This module has the ADCON0
and ADCON1 register definitions that are compatible
with the mid-range A/D module.
The A/D allows conversion of an analog input signal to
a corresponding 10-bit digital number.
REGISTER 16-1: ADCON0 REGISTER
R/W-0
ADCS1
bit 7
R/W-0
ADCS0
R/W-0
CHS2
The A/D module has four registers. These registers
are:
• A/D Result High Register (ADRESH)
• A/D Result Low Register (ADRESL)
• A/D Control Register 0 (ADCON0)
• A/D Control Register 1 (ADCON1)
The ADCON0 register, shown in Register 16-1, con-
trols the operation of the A/D module. The ADCON1
register, shown in Register 16-2, configures the func-
tions of the port pins.
R/W-0
CHS1
R/W-0
R/W-0
U-0
R/W-0
CHS0
GO/DONE
—
ADON
bit 0
bit 7-6
ADCS1:ADCS0: A/D Conversion Clock Select bits (ADCON0 bits in bold)
ADCON1
ADCON0
<ADCS2> <ADCS1:ADCS0>
Clock Conversion
0
00
FOSC/2
0
01
FOSC/8
0
10
FOSC/32
0
11
FRC (clock derived from the internal A/D RC oscillator)
1
00
FOSC/4
1
01
FOSC/16
1
10
FOSC/64
1
11
FRC (clock derived from the internal A/D RC oscillator)
bit 5-3
bit 2
bit 1
bit 0
CHS2:CHS0: Analog Channel Select bits
000 = channel 0 (AN0)
001 = channel 1 (AN1)
010 = channel 2 (AN2)
011 = channel 3 (AN3)
100 = channel 4 (AN4)
101 = channel 5 (AN5)
110 = channel 6 (AN6)
111 = channel 7 (AN7)
Note: The PIC18C2X2 devices do not implement the full 8 A/D channels; the unimplemented selections
are reserved. Do not select any unimplemented channel.
GO/DONE: A/D Conversion Status bit
When ADON = 1:
1 = A/D conversion in progress (setting this bit starts the A/D conversion which is automatically
cleared by hardware when the A/D conversion is complete)
0 = A/D conversion not in progress
Unimplemented: Read as '0'
ADON: A/D On bit
1 = A/D converter module is powered up
0 = A/D converter module is shut-off and consumes no operating current
Legend:
R = Readable bit
- n = Value at POR reset
W = Writable bit
’1’ = Bit is set
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared
x = Bit is unknown
 1999-2013 Microchip Technology Inc.
DS39026D-page 165