MC68HC908JW32_09 Datasheet, PDF (70/232 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Clock Generator Module (CGM)
5.5.3 PLL Multiplier Select Registers
The PLL multiplier select registers (PMSH and PMSL) contain the programming information for the
modulo feedback divider.
Address:
Read:
Write:
Reset:
$1092
Bit 7
6
5
4
3
2
1
0
0
0
0
MUL11 MUL10 MUL9
0
0
0
0
0
0
0
= Unimplemented
Figure 5-6. PLL Multiplier Select Register High (PMSH)
Bit 0
MUL8
0
Address:
Read:
Write:
Reset:
$1093
Bit 7
6
5
4
3
2
1
MUL7
MUL6
MUL5
MUL4
MUL3
MUL2
MUL1
0
1
0
0
0
0
0
Figure 5-7. PLL Multiplier Select Register Low (PMSL)
Bit 0
MUL0
0
MUL[11:0] — Multiplier Select Bits
These read/write bits control the modulo feedback divider that selects the VCO frequency multiplier N.
(See 5.3.3 PLL Circuits and 5.3.6 Programming the PLL.) A value of $0000 in the multiplier select
registers configure the modulo feedback divider the same as a value of $0001. Reset initializes the
registers to $0040 for a default multiply value of 64.
NOTE
The multiplier select bits have built-in protection such that they cannot be
written when the PLL is on (PLLON = 1).
5.5.4 PLL VCO Range Select Register
The PLL VCO range select register (PMRS) contains the programming information required for the
hardware configuration of the VCO.
Address:
Read:
Write:
Reset:
$1094
Bit 7
6
5
4
3
2
1
VRS7
VRS6
VRS5
VRS4
VRS3
VRS2
VRS1
0
1
0
0
0
0
0
Figure 5-8. PLL VCO Range Select Register (PMRS)
Bit 0
VRS0
0
VRS[7:0] — VCO Range Select Bits
These read/write bits control the hardware center-of-range linear multiplier L which, in conjunction with
E (See 5.3.3 PLL Circuits, 5.3.6 Programming the PLL, and 5.5.1 PLL Control Register.), controls the
hardware center-of-range frequency, f_VRS. VRS[7:0] cannot be written when the PLLON bit in the
PCTL is set. (See 5.3.7 Special Programming Exceptions.) A value of $00 in the VCO range select
MC68HC908JW32 Data Sheet, Rev. 6
70
Freescale Semiconductor