EP3C5E144C8N Datasheet, PDF (48/348 Pages) Altera Corporation – Ability to disable external JTAG port

3–14
Chapter 3: Memory Blocks in the Cyclone III Device Family
Clocking Modes
Clocking Modes
Cyclone III device family M9K memory blocks support the following clocking modes:
■ Independent
■ Input or output
■ Read or write
■ Single-clock
When using read or write clock mode, if you perform a simultaneous read or write to
the same address location, the output read data is unknown. If you require the output
data to be a known value, use either single-clock mode or I/O clock mode and choose
the appropriate read-during-write behavior in the MegaWizard Plug-In Manager.
1 Violating the setup or hold time on the memory block input registers might corrupt
the memory contents. This applies to both read and write operations.
1 Asynchronous clears are available on read address registers, output registers, and
output latches only.
Table 3–5 lists the clocking mode versus memory mode support matrix.
Table 3–5. Cyclone III Device Family Memory Clock Modes
Clocking Mode
True Dual-Port
Mode
Simple
Dual-Port
Mode
Single-Port
Mode
Independent
v
Input or output
v
Read or write
—
Single-clock
v
—
—
v
v
v
—
v
v
ROM Mode FIFO Mode
v
—
v
—
—
v
v
v
Independent Clock Mode
Cyclone III device family M9K memory blocks can implement independent clock
mode for true dual-port memories. In this mode, a separate clock is available for each
port (port A and port B). clock A controls all registers on the port A side, while clock
B controls all registers on the port B side. Each port also supports independent clock
enables for port A and B registers.
I/O Clock Mode
Cyclone III device family M9K memory blocks can implement input or output clock
mode for FIFO, single-port, true, and simple dual-port memories. In this mode, an
input clock controls all input registers to the memory block, including data, address,
byteena, wren, and rden registers. An output clock controls the data-output registers.
Each memory block port also supports independent clock enables for input and
output registers.
Cyclone III Device Handbook
Volume 1
December 2011 Altera Corporation