AK4679EG Datasheet, PDF (69/220 Pages) Asahi Kasei Microsystems – 24bit Stereo CODEC with DSP and MIC/RCV/HP/SPK/LINE-AMP

[AK4679]
■ Digital Programmable Filter
(1) High Pass Filter (HPF2)
Normally, this HPF is used for Wind-Noise Reduction. This is composed 1st order HPF. The coefficient of HPF is set by
F1A13-0 bits and F1B13-0 bits. HPF bit controls ON/OFF of the HPF2. When the HPF2 is OFF, the audio data passes
this block by 0dB gain. The coefficient must be set when HPF bit = “0” or PMPFIL bit = “0”. The HPF2 starts operation
4/fs(max) after when HPF bit = “1” and PMPFIL bit = “1” are set.
fs: Sampling frequency
fc: Cut-off frequency
Register setting (Note 77)
HPF: F1A[13:0] bits =A, F1B[13:0] bits =B
(MSB=F1A13, F1B13; LSB=F1A0, F1B0)
1 / tan (πfc/fs)
A=
,
1 + 1 / tan (πfc/fs)
1 − 1 / tan (πfc/fs)
B=
1 + 1 / tan (πfc/fs)
Transfer function
1 − z ^−1
H(z) = A
1 + Bz ^−1
The cut-off frequency should be set as below.
fc/fs ≥ 0.0001 (fc min = 4.41Hz at 44.1kHz)
(2) Low Pass Filter (LPF)
This is composed with 1st order LPF. F2A13-0 bits and F2B13-0 bits set the coefficient of LPF. LPF bit controls ON/OFF
of the LPF. When the LPF is OFF, the audio data passes this block by 0dB gain. The coefficient must be set when LPF bit
= “0” or PMPFIL bit = “0”. The LPF starts operation 4/fs(max) after when LPF bit = “1” and PMPFIL bit = “1” are set.
fs: Sampling frequency
fc: Cut-off frequency
Register setting (Note 77)
LPF: F2A[13:0] bits =A, F2B[13:0] bits =B
(MSB=F2A13, F1B13; LSB=F2A0, F2B0)
1
A=
,
1 + 1 / tan (πfc/fs)
1 − 1 / tan (πfc/fs)
B=
1 + 1 / tan (πfc/fs)
Transfer function
1 + z ^−1
H(z) = A
1 + Bz ^−1
The cut-off frequency should be set as below.
fc/fs ≥ 0.05 (fc min = 2205Hz at 44.1kHz)
MS1402-E-06
- 69 -
2013/02