DS90UB964-Q1 Datasheet, PDF (79/116 Pages) Texas Instruments – DS90UB964-Q1 Quad FPD-Link III Deserializer Hub

www.ti.com
DS90UB964-Q1
SNLS500 – JULY 2016
Register Maps (continued)
Page
RX
RX
RX
RX
Addr
(hex)
0x6A
0x6B
0x6C
0x6D
Register Name
SlaveAlias[5]
SlaveAlias[6]
SlaveAlias[7]
PORT_CONFIG
Table 12. Serial Control Bus Registers (continued)
Bit(s) Field
Type Default Description
0
SLAVE AUTO ACK 4 RW
7:1 SLAVE ALIAS ID5 RW
0
SLAVE AUTO ACK 5 RW
7:1 SLAVE ALIAS ID6 RW
0
SLAVE AUTO ACK 6 RW
7:1 SLAVE ALIAS ID7 RW
0
SLAVE AUTO ACK 7 RW
7:4 RESERVED
RW
3
DISCARD_1ST_LINE RW
_ON_ERR
2
COAX_MODE
RW
0
0x0
0
0x0
0
0x0
0
0x7
1
Strap
Automatically Acknowledge all I2C writes to
the remote Slave 4 independent of the forward
channel lock state or status of the remote
Serializer Acknowledge
1: Enable
0: Disable
7-bit Remote Slave Device Alias ID 5
Configures the decoder for detecting
transactions designated for an I2C Slave
device attached to the remote Serializer. The
transaction is remapped to the address
specified in the Slave ID5 register. A value of 0
in this field disables access to the remote I2C
Slave.
Automatically Acknowledge all I2C writes to
the remote Slave 5 independent of the forward
channel lock state or status of the remote
Serializer Acknowledge
1: Enable
0: Disable
7-bit Remote Slave Device Alias ID 6
Configures the decoder for detecting
transactions designated for an I2C Slave
device attached to the remote Serializer. The
transaction is remapped to the address
specified in the Slave ID6 register. A value of 0
in this field disables access to the remote I2C
Slave.
Automatically Acknowledge all I2C writes to
the remote Slave 6 independent of the forward
channel lock state or status of the remote
Serializer Acknowledge
1: Enable
0: Disable
7-bit Remote Slave Device Alias ID 7
Configures the decoder for detecting
transactions designated for an I2C Slave
device attached to the remote Serializer. The
transaction is remapped to the address
specified in the Slave ID7 register. A value of 0
in this field disables access to the remote I2C
Slave.
Automatically Acknowledge all I2C writes to
the remote Slave 7 independent of the forward
channel lock state or status of the remote
Serializer Acknowledge
1: Enable
0: Disable
Reserved
In RAW Mode, Discard first video line if FV to
LV setup time is not met.
0 : Forward truncated 1st video line
1 : Discard truncated 1st video line
Enable coax cable mode
0: Shielded twisted pair (STP) mode
1: Coax mode
Copyright © 2016, Texas Instruments Incorporated
Product Folder Links: DS90UB964-Q1
Submit Documentation Feedback
79