HD64F3687HV Datasheet, PDF (86/538 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 3 Exception Handling
3.2.3 Interrupt Enable Register 1 (IENR1)
IENR1 enables direct transition interrupts, RTC interrupts, and external pin interrupts.
Initial
Bit
Bit Name Value R/W Description
7
IENDT 0
R/W Direct Transfer Interrupt Enable
When this bit is set to 1, direct transition interrupt
requests are enabled.
6
IENTA 0
R/W RTC Interrupt Enable
When this bit is set to 1, RTC interrupt requests are
enabled.
5
IENWP 0
R/W Wakeup Interrupt Enable
This bit is an enable bit, which is common to the pins
WKP5 to WKP0. When the bit is set to 1, interrupt
requests are enabled.
4

1

Reserved
This bit is always read as 1.
3
IEN3
0
R/W IRQ3 Interrupt Enable
When this bit is set to 1, interrupt requests of the IRQ3
pin are enabled.
2
IEN2
0
R/W IRQ2 Interrupt Enable
When this bit is set to 1, interrupt requests of the IRQ2
pin are enabled.
1
IEN1
0
R/W IRQ1 Interrupt Enable
When this bit is set to 1, interrupt requests of the IRQ1
pin are enabled.
0
IEN0
0
R/W IRQ0 Interrupt Enable
When this bit is set to 1, interrupt requests of the IRQ0
pin are enabled.
When disabling interrupts by clearing bits in an interrupt enable register, or when clearing bits in
an interrupt flag register, always do so while interrupts are masked (I = 1). If the above clear
operations are performed while I = 0, and as a result a conflict arises between the clear instruction
and an interrupt request, exception handling for the interrupt will be executed after the clear
instruction has been executed.
Rev.5.00 Nov. 02, 2005 Page 52 of 500
REJ09B0027-0500