HD64F3687HV Datasheet, PDF (337/538 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 17 I²C Bus Interface 2 (IIC2)
Section 17 I²C Bus Interface 2 (IIC2)
The I²C bus interface 2 conforms to and provides a subset of the Philips I²C bus (inter-IC bus)
interface functions. The register configuration that controls the I²C bus differs partly from the
Philips configuration, however.
Figure 17.1 shows a block diagram of the I²C bus interface 2.
Figure 17.2 shows an example of I/O pin connections to external circuits.
17.1 Features
• Selection of I²C format or clocked synchronous serial format
• Continuous transmission/reception
Since the shift register, transmit data register, and receive data register are independent from
each other, the continuous transmission/reception can be performed.
I²C bus format
• Start and stop conditions generated automatically in master mode
• Selection of acknowledge output levels when receiving
• Automatic loading of acknowledge bit when transmitting
• Bit synchronization/wait function
In master mode, the state of SCL is monitored per bit, and the timing is synchronized
automatically.
If transmission/reception is not yet possible, set the SCL to low until preparations are
completed.
• Six interrupt sources
Transmit data empty (including slave-address match), transmit end, receive data full (including
slave-address match), arbitration lost, NACK detection, and stop condition detection
• Direct bus drive
Two pins, SCL and SDA pins, function as NMOS open-drain outputs when the bus drive
function is selected.
Clocked synchronous format
• Four interrupt sources
Transmit-data-empty, transmit-end, receive-data-full, and overrun error
IFIIC10A_000020020200
Rev.5.00 Nov. 02, 2005 Page 303 of 500
REJ09B0027-0500