HD64F3687HV Datasheet, PDF (385/538 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 19 EEPROM
19.2 Input/Output Pins
Pins used in the EEPROM are listed in table 19.1.
Table 19.1 Pin Configuration
Pin name
Serial clock pin
Serial data pin
Symbol Input/Output Function
SCL
Input
The SCL pin is used to control serial input/output data
timing. The data is input at the rising edge of the
clock and output at the falling edge of the clock. The
SCL pin needs to be pulled up by resistor as that pin
is open-drain driven structure of the I²C pin. Use
proper resistor value for your system by considering
V , I , and the C pin capacitance in section 23.2.2,
OL OL
IN
DC Characteristics and in section 23.2.3, AC
Characteristics. Maximum clock frequency is 400
kHz.
SDA
Input/Output
The SDA pin is bidirectional for serial data transfer.
The SDA pin needs to be pulled up by resistor as that
pin is open-drain driven structure. Use proper resistor
value for your system by considering V , I , and the
OL OL
C pin capacitance in section 23.2.2, DC
IN
Characteristics and in section 23.2.3, AC
Characteristics. Except for a start condition and a
stop condition which will be discussed later, the high-
to-low and low-to-high change of SDA input should be
done during SCL low periods.
19.3 Register Description
The EEPROM has a following register.
• EEPROM key register (EKR)
19.3.1 EEPROM Key Register (EKR)
EKR is an 8-bit readable/writable register, which changes the slave address code written in the
EEPROM. The slave address code is changed by writing H'5F in EKR and then writing either of
H'00 to H'07 as an address code to the H'FF09 address in the EEPROM by the byte write method.
EKR is initialized to H'FF.
Rev.5.00 Nov. 02, 2005 Page 351 of 500
REJ09B0027-0500