HD64F3687HV Datasheet, PDF (349/538 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 17 I²C Bus Interface 2 (IIC2)
Initial
Bit
Bit Name Value R/W Description
2
AL/OVE 0
R/W Arbitration Lost Flag/Overrun Error Flag
This flag indicates that arbitration was lost in master
mode with the I²C bus format and that the final bit has
been received while RDRF = 1 with the clocked
synchronous format.
When two or more master devices attempt to seize the
bus at nearly the same time, if the I²C bus interface
detects data differing from the data it sent, it sets AL to 1
to indicate that the bus has been taken by another
master.
[Setting conditions]
• If the internal SDA and SDA pin disagree at the rise of
SCL in master transmit mode
• When the SDA pin outputs high in master mode while
a start condition is detected
• When the final bit is received with the clocked
synchronous format while RDRF = 1
[Clearing condition]
• When 0 is written in AL/OVE after reading AL/OVE=1
1
AAS
0
R/W Slave Address Recognition Flag
In slave receive mode, this flag is set to 1 if the first frame
following a start condition matches bits SVA6 to SVA0 in
SAR.
[Setting conditions]
• When the slave address is detected in slave receive
mode
• When the general call address is detected in slave
receive mode.
[Clearing condition]
• When 0 is written in AAS after reading AAS=1
Rev.5.00 Nov. 02, 2005 Page 315 of 500
REJ09B0027-0500