HD64F3687HV Datasheet, PDF (313/538 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 16 Serial Communication Interface 3 (SCI3)
Start transmission
[1]
Read TDRE flag in SSR
No
TDRE = 1
Yes
Write transmit data to TDR
Yes
[2]
All data transmitted?
No
Read TEND flag in SSR
No
TEND = 1
Yes
No
[3]
Break output?
Yes
Clear PDR to 0 and
set PCR to 1
[1] Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. When data is
written to TDR, the TDRE flag is
automaticaly cleared to 0.
[2] To continue serial transmission,
read 1 from the TDRE flag to
confirm that writing is possible,
then write data to TDR. When data
is written to TDR, the TDRE flag is
automaticaly cleared to 0.
[3] To output a break in serial
transmission, after setting PCR to 1
and PDR to 0, clear TxD in PMR1
to 0, then clear the TE bit in SCR3
to 0.
Clear TE bit in SCR3 to 0
<End>
Figure 16.6 Sample Serial Transmission Data Flowchart (Asynchronous Mode)
Rev.5.00 Nov. 02, 2005 Page 279 of 500
REJ09B0027-0500