Z8F082ASH020SC Datasheet, PDF (93/244 Pages) Zilog, Inc. – Z8 Encore XP-R F08xA Series with eXtended Peripherals

Z8 Encore! XP^® F08xA Series
Product Specification
75
BITS
FIELD
RESET
R/W
ADDR
0x = Timer Interrupt occurs on all defined Reload, Compare and Input Events
10 = Timer Interrupt only on defined Input Capture/Deassertion Events
11 = Timer Interrupt only on defined Reload/Compare Events
Reserved—Must be 0.
PWMD—PWM Delay value
This field is a programmable delay to control the number of system clock cycles delay
before the Timer Output and the Timer Output Complement are forced to their active state.
000 = No delay
001 = 2 cycles delay
010 = 4 cycles delay
011 = 8 cycles delay
100 = 16 cycles delay
101 = 32 cycles delay
110 = 64 cycles delay
111 = 128 cycles delay
INPCAP—Input Capture Event
This bit indicates if the most recent timer interrupt is caused by a Timer Input Capture
Event.
0 = Previous timer interrupt is not a result of Timer Input Capture Event
1 = Previous timer interrupt is a result of Timer Input Capture Event
Timer 0–1 Control Register 1
The Timer 0–1 Control (TxCTL1) registers enable/disable the timers, set the prescaler
value, and determine the timer operating mode.
Table 54. Timer 0–1 Control Register 1 (TxCTL1)
7
6
5
4
3
TEN
TPOL
PRES
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
F07H, F0FH
2
1
0
TMODE
0
0
0
R/W
R/W
R/W
TEN—Timer Enable
0 = Timer is disabled.
1 = Timer enabled to count.
TPOL—Timer Input/Output Polarity
Operation of this bit is a function of the current operating mode of the timer.
ONE-SHOT mode
When the timer is disabled, the Timer Output signal is set to the value of this bit.
PS024705-0405
PRELIMINARY
Timers