Z8F082ASH020SC Datasheet, PDF (62/244 Pages) Zilog, Inc. – Z8 Encore XP-R F08xA Series with eXtended Peripherals

Z8 Encore! XP^® F08xA Series
Product Specification
44
R/W
ADDR
Table 27. Port A–D Output Data Register (PxOUT)
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
FD3H, FD7H, FDBH, FDFH
POUT[7:0]—Port Output Data
These bits contain the data to be driven to the port pins. The values are only driven if the
corresponding pin is configured as an output and the pin is not configured for alternate
function operation.
0 = Drive a logical 0 (Low).
1= Drive a logical 1 (High). High value is not driven if the drain has been disabled by set-
ting the corresponding Port Output Control register bit to 1.
LED Drive Enable Register
The LED Drive Enable register (Table 28) activates the controlled current drive. The Port
C pin must first be enabled by setting the Alternate Function register to select the LED
function.
.
Table 28. LED Drive Enable (LEDEN)
BITS
FIELD
RESET
R/W
ADDR
7
6
5
4
3
2
1
0
LEDEN[7:0]
0
0
0
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
F82H
LEDEN[7:0]—LED Drive Enable
These bits determine which Port C pins are connected to an internal current sink.
0 = Tristate the Port C pin.
1= Connect controlled current sink to the Port C pin.
LED Drive Level High Register
The LED Drive Level registers contain two control bits for each Port C pin (Table 29).
These two bits select between four programmable drive levels. Each pin is individually
programmable.
Table 29. LED Drive Level High Register (LEDLVLH)
BITS
7
6
5
4
3
2
1
0
FIELD
LEDLVLH[7:0]
RESET
0
0
0
0
0
0
0
0
PS024705-0405
PRELIMINARY
General-Purpose I/O