C8051F352 Datasheet, PDF (17/234 Pages) Silicon Laboratories – 8 k ISP Flash MCU Family

C8051F350/1/2/3
1. System Overview
C8051F350/1/2/3 devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features
are listed below. Refer to Table 1.1 for specific product feature selection.
• High-speed pipelined 8051-compatible microcontroller core (up to 50 MIPS)
• In-system, full-speed, non-intrusive debug interface (on-chip)
• 24 or 16-bit single-ended/differential ADC with analog multiplexer
• Two 8-bit Current Output DACs
• Precision programmable 24.5 MHz internal oscillator
• 8 kB of on-chip Flash memory
• 768 bytes of on-chip RAM
• SMBus/I2C, Enhanced UART, and SPI serial interfaces implemented in hardware
• Four general-purpose 16-bit timers
• Programmable counter/timer array (PCA) with three capture/compare modules and watchdog timer
function
• On-chip power-on reset, V_DD monitor, and temperature sensor
• On-chip voltage comparator
• 17 Port I/O (5 V tolerant)
With on-chip power-on reset, V_DD monitor, watchdog timer, and clock oscillator, the C8051F350/1/2/3
devices are truly stand-alone System-on-a-Chip solutions. The Flash memory can be reprogrammed even
in-circuit, providing non-volatile data storage, and also allowing field upgrades of the 8051 firmware. User
software has complete control of all peripherals, and may individually shut down any or all peripherals for
power savings.
The on-chip Silicon Labs 2-Wire (C2) Development Interface allows non-intrusive (uses no on-chip
resources), full speed, in-circuit debugging using the production MCU installed in the final application. This
debug logic supports inspection and modification of memory and registers, setting breakpoints, single
stepping, run and halt commands. All analog and digital peripherals are fully functional while debugging
using C2. The two C2 interface pins can be shared with user functions, allowing in-system debugging with-
out occupying package pins.
Each device is specified for 2.7 to 3.6 V operation over the industrial temperature range (–45 to +85 °C).
The Port I/O and /RST pins are tolerant of input signals up to 5 V. The C8051F350/1/2/3 are available in
28-pin QFN (also referred to as MLP or MLF) or 32-pin LQFP packaging, as shown in Figure 1.1 through
Figure 1.4.
Rev. 1.1
17