M16C28 Datasheet, PDF (249/423 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/Tiny SERIES

M16C/28 Group (M16C/28, M16C/28B)
15. A/D Converter
15.1.4 Repeat Sweep Mode 0
In repeat sweep mode 0, analog voltages applied to the selected pins are repeatedly converted to a
digital code. Table 15.6 shows the repeat sweep mode 0 specifications. Figure 15.12 shows the opera-
tion example in repeat sweep mode 0. Figure 15.13 shows the ADCON0 to ADCON2 registers in repeat
sweep mode 0.
Table 15.6 Repeat Sweep Mode 0 Specifications
Item
Specification
Function
The SCAN1 to SCAN0 bits in the ADCON1 register and the ADGSEL1 to
ADGSEL0 bits in the ADCON2 register select pins. Analog voltage applied to
the selected pins is repeatedly converted to a digital code
A/D Conversion Start Condition • When the TRG bit in the ADCON0 register is “0” (software trigger)
Set the ADST bit in the ADCON0 register to “1” (A/D conversion started)
• When the TRG bit in the ADCON0 register is “1” (Hardware trigger)
The ADTRG pin input changes state from “H” to “L” after setting the ADST bit
to “1” (A/D conversion started)
A/D Conversion Stop Condition Set the ADST bit to “0” (A/D conversion halted)
Interrupt Request Generation Timing None generated
Analog Input Pin
Select from AN0 to AN1 (2 pins), AN0 to AN3 (4 pins), AN0 to AN5 (6 pins),
AN0 to AN7 (8 pins) ⁽¹⁾
Readout of A/D Conversion Result Readout one of the AD0 to AD7 registers that corresponds to the selected pin
NOTES:
1. AN00 to AN07 and AN20 to AN27 can be used in the same way as AN0 to AN7. However, all input pins
need to belong to the same group.
•Example when selecting AN0 to AN3 to A/D sweep pins (SCAN1 to SCAN0="012")
A/D conversion started
AN0
AN1
AN2
AN3
AN4
AN5
AN6
AN7
Figure 15.12 Operation Example in Repeat Sweep Mode 0
A/D pin input voltage
sampling
A/D pin conversion
Rev. 2.00 Jan. 31, 2007 ^{page 229} of 385
REJ09B0047-0200