PIC18F258 Datasheet, PDF (329/384 Pages) Microchip Technology – High Performance, 28/40-Pin Enhanced FLASH Microcontrollers with CAN

PIC18FXX8
27.1 DC Characteristics
PIC18LFXX8
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
PIC18FXX8
(Industrial, Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Symbol
Characteristic/
Device
Min Typ⁽⁵⁾ Max Units
Conditions
VDD
Supply Voltage
D001
PIC18LFXX8 2.0 — 5.5 V HS, XT, RC and LP osc mode
D001
PIC18FXX8 4.2 — 5.5 V
D002 VDR
RAM Data Retention
Voltage⁽¹⁾
1.5 — — V
D003 VPOR
VDD Start Voltage
to ensure internal
Power-on Reset signal
— — 0.7 V See section on Power-on Reset for details
D004 SVDD
VDD Rise Rate
to ensure internal
Power-on Reset signal
0.05 — — V/ms See section on Power-on Reset for details
VBOR Brown-out Reset Voltage
PIC18LFXX8
D005
BORV1:BORV0 = 11 2.0 — 2.16 V
BORV1:BORV0 = 10 2.7 — 2.86 V
BORV1:BORV0 = 01 4.2 — 4.46 V
BORV1:BORV0 = 00 4.5 — 4.78 V
PIC18FXX8
D005
BORV1:BORV0 = 1x N.A. — N.A. V Not in operating voltage range of device
BORV1:BORV0 = 01 4.2 — 4.46 V
BORV1:BORV0 = 00 4.5 — 4.78 V
Legend: Shading of rows is to assist in readability of the table.
Note 1: This is the limit to which VDD can be lowered in SLEEP mode or during a device RESET, without losing
RAM data.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
The test conditions for all IDD measurements in Active Operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD
MCLR = VDD; WDT enabled/disabled as specified.
3: The power-down current in SLEEP mode does not depend on the oscillator type. Power-down current is
measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD or VSS, and
all features that add delta current disabled (such as WDT, Timer1 Oscillator, BOR, ...).
4: For RC osc configuration, current through REXT is not included. The current through the resistor can be
estimated by the formula Ir = VDD/2REXT (mA) with REXT in kOhm.
5: Typical is taken at 25°C.
 2002 Microchip Technology Inc.
Preliminary
DS41159B-page 327