LAN9311 Datasheet, PDF (322/461 Pages) SMSC Corporation – Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
14.5.1.3 Switch Global Interrupt Mask Register (SW_IMR)
Register #:
0004h
Size:
32 bits
This read/write register contains the global interrupt mask for the switch fabric interrupts. All switch
related interrupts in the Switch Global Interrupt Pending Register (SW_IPR) may be masked via this
register. An interrupt is masked by setting the corresponding bit of this register. Clearing a bit will
unmask the interrupt. When an unmasked switch fabric interrupt is generated in the Switch Global
Interrupt Pending Register (SW_IPR), the interrupt will trigger the SWITCH_INT bit in the Interrupt
Status Register (INT_STS). Refer to Chapter 5, "System Interrupts," on page 49 for more information.
BITS
31:9
8:7
6
5
4:3
2
1
0
DESCRIPTION
RESERVED
RESERVED
Note: These bits must be written as 11b
Buffer Manager Interrupt Mask (BM)
When set, prevents the generation of switch fabric interrupts due to the
Buffer Manager via the Buffer Manager Interrupt Pending Register
(BM_IPR). The status bits in the SW_IPR register are not affected.
Switch Engine Interrupt Mask (SWE)
When set, prevents the generation of switch fabric interrupts due to the
Switch Engine via the Switch Engine Interrupt Pending Register (SWE_IPR).
The status bits in the SW_IPR register are not affected.
RESERVED
Note: These bits must be written as 11b
Port 2 MAC Interrupt Mask (MAC_2)
When set, prevents the generation of switch fabric interrupts due to the Port
2 MAC via the MAC_IPR_2 register (see Section 14.5.2.44, on page 367).
The status bits in the SW_IPR register are not affected.
Port 1 MAC Interrupt Mask (MAC_1)
When set, prevents the generation of switch fabric interrupts due to the Port
1 MAC via the MAC_IPR_1 register (see Section 14.5.2.44, on page 367).
The status bits in the SW_IPR register are not affected.
Port 0 MAC Interrupt Mask (MAC_MII)
When set, prevents the generation of switch fabric interrupts due to the Port
0 MAC via the MAC_IPR_MII register (see Section 14.5.2.44, on page 367).
The status bits in the SW_IPR register are not affected.
TYPE
RO
R/W
R/W
R/W
R/W
R/W
R/W
R/W
DEFAULT
-
11b
1b
1b
11b
1b
1b
1b
Revision 2.0 (02-14-13)
322
DATASHEET
SMSC LAN9311/LAN9311i