LAN9311 Datasheet, PDF (29/461 Pages) SMSC Corporation – Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
Note 3.1
The pin names for the twisted pair pins apply to a normal connection. If HP Auto-MDIX is
enabled and a reverse connection is detected or manually selected, the RX and TX pins
will be swapped internally.
Table 3.2 LAN Port 2 Pins
BUFFER
PIN
NAME
SYMBOL
TYPE
DESCRIPTION
83-86
127
126
124
123
Port 2 LED
Indicators
General
Purpose I/O
Data
Port 2
Ethernet TX
Negative
Port 2
Ethernet TX
Positive
Port 2
Ethernet RX
Negative
Port 2
Ethernet RX
Positive
nP2LED[3:0]
GPIO[7:4]
TXN2
TXP2
RXN2
RXP2
OD12
IS/O12/
OD12
(PU)
AIO
AIO
AIO
AIO
LED indicators: When configured as LED outputs
via the LED Configuration Register (LED_CFG),
these pins are open-drain, active low outputs and
the pull-ups and input buffers are disabled. The
functionality of each pin is determined via the
LED_CFG[9:8] bits.
General Purpose I/O Data: When configured as
GPIO via the LED Configuration Register
(LED_CFG), these general purpose signals are
fully programmable as either push-pull outputs,
open-drain outputs or Schmitt-triggered inputs by
writing the General Purpose I/O Configuration
Register (GPIO_CFG) and General Purpose I/O
Data & Direction Register (GPIO_DATA_DIR). The
pull-ups are enabled in GPIO mode. The input
buffers are disabled when set as an output.
Note: See Chapter 13, "GPIO/LED Controller,"
on page 163 for additional details.
Ethernet TX Negative: Negative output of Port 2
Ethernet transmitter. See Note 3.2 for additional
information.
Ethernet TX Positive: Positive output of Port 2
Ethernet transmitter. See Note 3.2 for additional
information.
Ethernet RX Negative: Negative input of Port 2
Ethernet receiver. See Note 3.2 for additional
information.
Ethernet RX Positive: Positive input of Port 2
Ethernet receiver. See Note 3.2 for additional
information.
Note 3.2
The pin names for the twisted pair pins apply to a normal connection. If HP Auto-MDIX is
enabled and a reverse connection is detected or manually selected, the RX and TX pins
will be swapped internally.
PIN
119
114,117
Table 3.3 LAN Port 1 & 2 Power and Common Pins
NAME
Bias
Reference
+3.3V Port 1
Analog Power
Supply
SYMBOL
EXRES
VDD33A1
BUFFER
TYPE
DESCRIPTION
AI
Bias Reference: Used for internal bias circuits.
Connect to an external 12.4K ohm, 1% resistor to
ground.
P
+3.3V Port 1 Analog Power Supply
Refer to the LAN9311/LAN9311i reference
schematic for additional connection information.
SMSC LAN9311/LAN9311i
29
DATASHEET
Revision 2.0 (02-14-13)