MC68HC05PV8 Datasheet, PDF (102/196 Pages) Freescale Semiconductor, Inc – Techinal Data - rev 1.9

Technical Data
Freescale Semiconductor, Inc.
PB2IC – PB2 Input Capture Enable
This bit enables the PB2 pin to drive the input capture channel 2.
1 = PB2 drives the input capture channel 2
0 = PC2 drives the input capture channel 2
PB1OC – PB1 Output Compare Enable
This bit enables the PB1 pin for output compare channel 1.
1 = PB1 output compare channel 1 enabled. PBDD1 bit must be set
in order to drive the output
0 = PB1 output compare channel 1disabled
PB0IC – PB0 Input Capture Enable
This bit enables the PB0 pin to drive the input capture channel 1.
1 = PB0 drives the input capture channel 1
0 = PC0 or PC4 drives the input capture channel 1
7.6 Port C (High Voltage Port)
Port C is a 7-bit multifunctional and bidirectional port (PC0–6) with high
voltage capability. The port is shared with timer and PWM channels
(TCAP, TCMP, PWM) and provides a special contact sense feature with
interrupt capability.
In addition, port C comprises a low ohmic two channel low side driver
with internal Zener diode turn-off for switching inductive loads.
The port C data register is at $0002 and the data direction register (DDR)
is at $0006. Reset does not affect the data registers, but clears the data
direction registers, thereby returning the PC0–4 to high voltage inputs,
PC5 and PC6 are switched to the off state. Writing a one to a DDR bit
sets the corresponding port bit to output or contact sense mode.
The port C pins PC5–6 are open drain outputs only without internal
pull-ups.
The voltage levels of PC0–4 I/O signals are related to the V_SUP and V_SS
levels respectively. PC5–6 have an additional power supply pin for VSS
(PVSS) to which the low side drivers relate.
Technical Data
MC68HC(8)05PV8/A — Rev. 1.9
Input/Output Ports
For More Information On This Product,
Go to: www.freescale.com