Z8F0113HJ005EG Datasheet, PDF (117/245 Pages) Zilog, Inc. – High-Performance 8-Bit Microcontrollers

Z8 Encore! XP^® F0823 Series
Product Specification
102
7. Return to Step 4 to receive additional data.
Receiving Data Using the Interrupt-Driven Method
The UART Receiver interrupt indicates the availability of new data (as well as error condi-
tions). Observe the following steps to configure the UART receiver for interrupt-driven
operation:
1. Write to the UART Baud Rate High and Low Byte registers to set the acceptable baud
rate.
2. Enable the UART pin functions by configuring the associated GPIO port pins for
alternate function operation.
3. Execute a DI instruction to disable interrupts.
4. Write to the Interrupt control registers to enable the UART Receiver interrupt and set
the acceptable priority.
5. Clear the UART Receiver interrupt in the applicable Interrupt Request register.
6. Write to the UART Control 1 Register to enable Multiprocessor (9-bit) mode func-
tions, if appropriate.
– Set the Multiprocessor Mode Select (MPEN) to Enable MULTIPROCESSOR
Mode
– Set the Multiprocessor Mode Bits, MPMD[1:0], to select the acceptable address
matching scheme
– Configure the UART to interrupt on received data and errors or errors only (inter-
rupt on errors only is unlikely to be useful for Z8 Encore! XP devices without a
DMA block)
7. Write the device address to the Address Compare Register (automatic MULTIPRO-
CESSOR modes only).
8. Write to the UART Control 0 Register to:
– Set the receive enable bit (REN) to enable the UART for data reception
– Enable parity, if appropriate and if multiprocessor mode is not enabled, and select
either even or odd parity
9. Execute an EI instruction to enable interrupts.
The UART is now configured for interrupt-driven data reception. When the UART
Receiver interrupt is detected, the associated interrupt service routine (ISR) performs the
following:
PS024315-1011
PRELIMINARY
Operation