JDP2S01T Datasheet, PDF (111/150 Pages) Toshiba Semiconductor – UHF~VHF Band RF Attenuator Applications

Philips Semiconductors
ISP1362
Single-chip USB OTG controller
• If the packet length is odd, the upper byte of the last word in an IN endpoint buffer
is not transmitted to the host. When reading from an OUT endpoint buffer, the
upper byte of the last word must be ignored by the firmware. The packet length is
stored in the first two bytes of the endpoint buffer.
Table 107: DC command and register summary
Name
Destination
Code (Hex)
Initialization commands
Write Control OUT Configuration
DcEndpointConfiguration register 20
endpoint 0 OUT
Write Control IN Configuration
DcEndpointConfiguration register 21
endpoint 0 IN
Write Endpoint n Configuration
(n = 1 to 14)
DcEndpointConfiguration register 22 to 2F
endpoint 1 to 14
Read Control OUT Configuration
DcEndpointConfiguration register 30
endpoint 0 OUT
Read Control IN Configuration
DcEndpointConfiguration register 31
endpoint 0 IN
Read Endpoint n Configuration
(n = 1 to 14)
DcEndpointConfiguration register 32 to 3F
endpoint 1 to 14
Write or read Device Address
DcAddress register
B6/B7
Write or read Mode register
DcMode register
B8/B9
Write or read Hardware Configuration DcHardwareConfiguration register BA/BB
Write or read DcInterruptEnable
register
DcInterruptEnable register
C2/C3
Write or read DMA Configuration
DcDMAConfiguration register
F0/F1
Write or read DMA Counter
DcDMACounter register
F2/F3
Reset Device
resets all registers
F6
Data flow commands
Write Control OUT Buffer
illegal: endpoint is read-only
(00)
Write Control IN Buffer
buffer memory endpoint 0 IN
01
Write Endpoint n Buffer
(n = 1 to 14)
buffer memory endpoint 1 to 14
(IN endpoints only)
02 to 0F
Read Control OUT Buffer
Read Control IN Buffer
Read Endpoint n Buffer
(n = 1 to 14)
buffer memory endpoint 0 OUT
illegal: endpoint is write-only
buffer memory endpoint 1 to 14
(OUT endpoints only)
10
(11)
12 to 1F
Stall Control OUT Endpoint
Stall Control IN Endpoint
Stall Endpoint n
(n = 1 to 14)
Read Control OUT Status
Read Control IN Status
Endpoint 0 OUT
Endpoint 0 IN
Endpoint 1 to 14
DcEndpointStatus register
endpoint 0 OUT
DcEndpointStatus register
endpoint 0 IN
40
41
42 to 4F
50
51
Transaction^[1]
write 1 byte^[2]
write 1 byte^[2]
write 1 byte^[2]
read 1 byte^[2]
read 1 byte^[2]
read 1 byte^[2]
write or read 1 byte^[2]
write or read 1 byte^[2]
write or read 2 bytes
write or read 4 bytes
write or read 2 bytes
write or read 2 bytes
-
-
N ≤ 64 bytes
isochronous:
N ≤ 1023 bytes
interrupt/bulk: N ≤ 64 bytes
N ≤ 64 bytes
-
isochronous:
N ≤ 1023 bytes^[4]
interrupt/bulk: N ≤ 64 bytes
-
-
-
read 1 byte^[2]
read 1 byte^[2]
9397 750 12337
Product data
Rev. 03 — 06 January 2004
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
111 of 150