LM3S5R36_13 Datasheet, PDF (548/1063 Pages) Texas Instruments – LM3S5R36 Microcontroller

NRND: Not recommended for new designs.
Analog-to-Digital Converter (ADC)
Figure 12-16. High-Band Operation (CIC=0x3 and/or CTC=0x3)
COMP1
COMP0
Always – 0 0 0 0 1 1 1 0 0 1 1 0 0 0 1 1
Once – 0 0 0 0 1 0 0 0 0 1 0 0 0 0 1 0
Hysteresis Always – 0 0 0 0 1 1 1 1 1 1 1 1 0 0 1 1
Hysteresis Once – 0 0 0 0 1 0 0 0 0 0 0 0 0 0 1 0
12.4
12.4.1
Initialization and Configuration
In order for the ADC module to be used, the PLL must be enabled and programmed to a supported
crystal frequency in the RCC register (see page 216). Using unsupported frequencies can cause
faulty operation in the ADC module.
Module Initialization
Initialization of the ADC module is a simple process with very few steps: enabling the clock to the
ADC, disabling the analog isolation circuit associated with all inputs that are to be used, and
reconfiguring the sample sequencer priorities (if needed).
The initialization sequence for the ADC is as follows:
1. Enable the ADC clock by using the RCGC0 register (see page 257).
2. Enable the clock to the appropriate GPIO modules via the RCGC2 register (see page 274). To
find out which GPIO ports to enable, refer to “Signal Description” on page 532.
3. Set the GPIO AFSEL bits for the ADC input pins (see page 428). To determine which GPIOs to
configure, see Table 22-4 on page 986.
4. Configure the AINx and VREFA signals to be analog inputs by clearing the corresponding DEN
bit in the GPIO Digital Enable (GPIODEN) register (see page 439).
5. Disable the analog isolation circuit for all ADC input pins that are to be used by writing a 1 to
the appropriate bits of the GPIOAMSEL register (see page 444) in the associated GPIO block.
548
October 06, 2012
Texas Instruments-Production Data