HD64F7045F28V Datasheet, PDF (404/925 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7040 Series

• Initial output in complementary PWM mode
In complementary PWM mode, the initial output is determined by the setting of bits OLSN and
OLSP in the timer output control register (TOCR).
This initial output is the PWM pulse non-active level, and is output from when complementary
PWM mode is set with the timer mode register (TMDR) until TCNT4 exceeds the value set in
the dead time register (TDDR). Figure 12.43 shows an example of the initial output in
complementary PWM mode.
An example of the waveform when the initial PWM duty value is smaller than the TDDR
value is shown in figure 12.44.
Timer output control register settings
OLSN bit: 0 (initial output: high; active level: low)
OLSP bit: 0 (initial output: high; active level: low)
TCNT3, 4 value
TGR4A
TCNT3
TCNT4
Positive phase
output
Negative phase
output
TDDR
Initial output
Dead time
Active level
Active level
Time
Complementary
PWM mode
(TMDR setting)
TCNT3, 4 count start
(TSTR setting)
Figure 12.43 Example of Initial Output in Complementary PWM Mode (1)
364