HD64F7045F28V Datasheet, PDF (284/925 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7040 Series

11.3.7 Bus Modes
Select the appropriate bus mode in the TM bits of CHCR0–CHCR3. There are two bus modes:
cycle steal and burst.
Cycle-Steal Mode: In the cycle steal mode, the bus right is given to another bus master after each
one-transfer-unit (byte, word, or longword) DMAC transfer. When the next transfer request
occurs, the bus rights are obtained from the other bus master and a transfer is performed for one
transfer unit. When that transfer ends, the bus right is passed to the other bus master. This is
repeated until the transfer end conditions are satisfied.
The cycle steal mode can be used with all categories of transfer destination, transfer source and
transfer request. Figure 11.12 shows an example of DMA transfer timing in the cycle steal mode.
Transfer conditions are dual address mode and DREQ level detection.
DREQ
Bus control returned to CPU
Bus cycle
CPU
CPU CPU DMAC DMAC CPU DMAC DMAC CPU CPU
Read Write
Read Write
Figure 11.12 DMA Transfer Example in the Cycle-Steal Mode
Burst Mode: Once the bus right is obtained, the transfer is performed continuously until the
transfer end condition is satisfied. In the external request mode with low level detection of the
DREQ pin, however, when the DREQ pin is driven high, the bus passes to the other bus master
after the bus cycle of the DMAC that currently has an acknowledged request ends, even if the
transfer end conditions have not been satisfied.
Figure 11.13 shows an example of DMA transfer timing in the burst mode. Transfer conditions are
single address mode and DREQ level detection.
DREQ
Bus cycle CPU CPU CPU DMAC DMAC DMAC DMAC DMAC DMAC CPU
Figure 11.13 DMA Transfer Example in the Burst Mode
244