M30222 Datasheet, PDF (81/237 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

deUvnedloepr ^ment
MITSUBISHI MICROCOMPUTERS
Specifications in this manual are tentative and subject to change
M30222 Group
Rev. G
Timer A
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Condition : Reload register = 0003 16 , when external trigger
(rising edge of TA iIN pin input signal) is selected
1 / fi X (2 ¹⁶ – 1)
Count source
TA iIN pin
“H”
input signal
“L”
PWM pulse output ^{“H”}
from TA iOUT pin
“L”
Timer Ai interrupt “1”
request bit
“0”
Trigger is not generated by this signal
Note: n = 0000
1 / fi X n
fi : Frequency of count source
(f1, f8, f32, fC32)
Cleared to “0” when interrupt request is accepted, or cleared by software
Note: n = 000016 to FFFE16
Fig. 1.56. Example of how a 16-bit pulse width modulator operates
Condition :
Reload register high-order 8 bits = 0216
Reload register low-order 8 bits = 0216
External trigger (falling edge of TAiIN pin input signal) is selected
Count source (Note1)
1 / fi X (m + 1) X (2 ⁸– 1)
TA iIN pin input signal ^{“H”}
“L”
Underflow signal of
“H”
8-bit prescaler (Note2) _{“L”}
PWM pulse output
“H”
from TA iOUT pin
“L”
Timer Ai interrupt
“1”
request bit
“0”
1 / fi X (m + 1)
1 / fi X (m + 1) X n
fi : Frequency of count source
(f1, f8, f32, fC32)
Cleared to “0” when interrupt request is accepted, or cleared by software
Note 1: The 8-bit prescaler counts the count source.
Note 2: The 8-bit pulse width modulator counts the 8-bit prescaler's underflow signal.
Note 3: m = 0016 to FE16; n = 0016 to FE16
Fig. 1.57. Example of how an 8-bit pulse width modulator operates
1-82