PIC24FJ128GC010 Datasheet, PDF (238/472 Pages) Microchip Technology – 16-Bit Flash Microcontrollers with 12-Bit Pipeline A/D, Sigma-Delta A/D, USB On-The-Go and XLP Technology

PIC24FJ128GC010 FAMILY
To set up the SPI module for the Standard Master mode
of operation:
1. If using interrupts:
a) Clear the SPIxIF bit in the respective IFSx
register.
b) Set the SPIxIE bit in the respective IECx
register.
c) Write the SPIxIP bits in the respective IPCx
register to set the interrupt priority.
2. Write the desired settings to the SPIxCON1
and SPIxCON2 registers with MSTEN
(SPIxCON1<5>) = 1.
3. Clear the SPIROV bit (SPIxSTAT<6>).
4. Enable SPI operation by setting the SPIEN bit
(SPIxSTAT<15>).
5. Write the data to be transmitted to the SPIxBUF
register. Transmission (and reception) will start
as soon as data is written to the SPIxBUF
register.
To set up the SPI module for the Standard Slave mode
of operation:
1. Clear the SPIxBUF register.
2. If using interrupts:
a) Clear the SPIxIF bit in the respective IFSx
register.
b) Set the SPIxIE bit in the respective IECx
register.
c) Write the SPIxIP bits in the respective IPCx
register to set the interrupt priority.
3. Write the desired settings to the SPIxCON1
and SPIxCON2 registers with MSTEN
(SPIxCON1<5>) = 0.
4. Clear the SMP bit.
5. If the CKE bit (SPIxCON1<8>) is set, then the
SSEN bit (SPIxCON1<7>) must be set to enable
the SSx pin.
6. Clear the SPIROV bit (SPIxSTAT<6>).
7. Enable SPI operation by setting the SPIEN bit
(SPIxSTAT<15>).
FIGURE 16-1:
SPIx MODULE BLOCK DIAGRAM (STANDARD MODE)
SCKx
SSx/FSYNCx
SDOx
SDIx
Sync
Control
Control
Clock
Select
Edge
Shift Control
bit 0
SPIxSR
1:1 to 1:8
Secondary
Prescaler
1:1/4/16/64
Primary
FCY
Prescaler
SPIxCON1<1:0>
SPIxCON1<4:2>
Enable
Master Clock
Transfer
Transfer
Read SPIxBUF
SPIxBUF
Write SPIxBUF
16
Internal Data Bus
DS30009312B-page 238
 2012-2013 Microchip Technology Inc.