MC68HC908GP20 Datasheet, PDF (142/406 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

LVISTOP — LVI Enable in Stop Mode Bit
When the LVIPWRD bit is clear, setting the LVISTOP bit enables the
LVI to operate during stop mode. Reset clears LVISTOP. (See
3.6.2 Stop Mode.)
1 = LVI enabled during stop mode
0 = LVI disabled during stop mode
LVIRSTD — LVI Reset Disable Bit
LVIRSTD disables the reset signal from the LVI module. (See Section
14. Low-Voltage Inhibit (LVI).)
1 = LVI module resets disabled
0 = LVI module resets enabled
LVIPWRD — LVI Power Disable Bit
LVIPWRD disables the LVI module. (See Section 14. Low-Voltage
Inhibit (LVI).)
1 = LVI module power disabled
0 = LVI module power enabled
LVI5OR3 — LVI 5-V or 3-V Operating Mode Bit
LVI5OR3 selects the voltage operating mode of the LVI module. (See
Section 14. Low-Voltage Inhibit (LVI).) The voltage mode selected
for the LVI should match the operating V_DD. See Section 23.
Preliminary Electrical Specifications for the LVI’s voltage trip points
for each of the modes.
1 = LVI operates in 5-V mode.
0 = LVI operates in 3-V mode.
SSREC — Short Stop Recovery Bit
SSREC enables the CPU to exit stop mode with a delay of 32
CGMXCLK cycles instead of a 4096-CGMXCLK cycle delay.
1 = Stop mode recovery after 32 CGMXCLK cycles
0 = Stop mode recovery after 4096 CGMXCLKC cycles
NOTE: Exiting stop mode by pulling reset will result in the long stop recovery.
If using an external crystal oscillator, do not set the SSREC bit.
Advance Information
142
MC68HC908GP20 — Rev 2.1
Freescale Semiconductor