HD64F3670 Datasheet, PDF (135/323 Pages) Renesas Technology Corp – Hitachi Single-Chip Microcomputer

Section 10 Timer V
Timer V is an 8-bit timer based on an 8-bit counter. Timer V counts external events. Compare-
match signals with two registers can also be used to reset the counter, request an interrupt, or
output a pulse signal with an arbitrary duty cycle. Counting can be initiated by a trigger input at
the TRGV pin, enabling pulse output control to be synchronized to the trigger, with an arbitrary
delay from the trigger input. Figure 10.1 shows a block diagram of timer V.
10.1 Features
• Choice of seven clock signals is available.
Choice of six internal clock sources (ø/128, ø/64, ø/32, ø/16, ø/8, ø/4) or an external clock.
• Counter can be cleared by compare match A or B, or by an external reset signal. If the count
stop function is selected, the counter can be halted when cleared.
• Timer output is controlled by two independent compare match signals, enabling pulse output
with an arbitrary duty cycle, PWM output, and other applications.
• Three interrupt sources: compare match A, compare match B, timer overflow
• Counting can be initiated by trigger input at the TRGV pin. The rising edge, falling edge, or
both edges of the TRGV input can be selected.
TIM08V0A_000020020300
Rev. 2.0, 03/02, page 111 of 298