MC68HC11P2 Datasheet, PDF (54/268 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
Operating Modes and On-Chip Memory
These bits can be read at any time. The value read is the one latched
into the register from the EEPROM cells during the last reset sequence.
A new value programmed into this register is not readable until after a
subsequent reset sequence. Unused bits always read as ones.
If SMOD = 1, CONFIG bits can be written at any time. If SMOD = 0,
CONFIG bits can only be written using the EEPROM programming
sequence, and are neither readable nor active until latched via the next
reset.
ROMAD — ROM mapping control
1 = ROM addressed from $8000 to $FFFF.
0 = ROM addressed from $0000 to $7FFF (expanded mode only).
In single chip mode, reset sets this bit.
Bits [6,5] — Not implemented; always read one
PAREN — Pull-up assignment register enable (see Parallel
Input/Output)
1 = PPAR register enabled; pull-ups can be enabled using PPAR.
0 = PPAR register disabled; all pull-ups disabled.
NOSEC — EEPROM security disabled (see RAM and EEPROM
security)
1 = Disable security.
0 = Enable security.
NOCOP — COP system disable (see Resets and Interrupts)
1 = COP system disabled.
0 = COP system enabled (forces reset on timeout).
ROMON — ROM enable
1 = ROM included in the memory map.
0 = ROM excluded from the memory map.
In single chip mode, reset sets this bit. In special test mode, reset
clears ROMON.
EEON — EEPROM enable
1 = EEPROM included in the memory map.
Technical Data
Operating Modes and On-Chip Memory
For More Information On This Product,
Go to: www.freescale.com
MC68HC11P2 — Rev 1.0