MC68HC11P2 Datasheet, PDF (24/268 Pages) Motorola, Inc – Microcontrollers

Pin Descriptions
Freescale Semiconductor, Inc.
V_DD
V_DD
2
4.7 k¾
IN
1
RESET
MC34064
GND
V_DD
3
To M68HC11
RESET
Manual
reset
4.7 k¾
4.7 k¾
2
1 µF
IN
RESET ¹
MC34164
GND
3
Figure 2-2. External reset circuitry
2.5 Crystal driver and external clock input (XTAL, EXTAL)
These two pins provide the interface for either a crystal or a CMOS
compatible clock to control the internal clock generator circuitry. The
frequency applied to these pins must be four times higher than the
desired E clock rate (unless the PLL circuit is used to provide the E
clock).
The XTAL pin is normally left unconnected when an external CMOS
compatible clock input is connected to the EXTAL pin. However, a 10 k¾
to 100 k¾ load resistor connected from XTAL to ground can be used to
reduce RFI noise emission. The XTAL output is normally intended to
drive only a crystal. The XTAL output can be buffered with a high-
impedance buffer, or it can be used to drive the EXTAL input of another
M68HC11 family device.
Technical Data
Pin Descriptions
For More Information On This Product,
Go to: www.freescale.com
MC68HC11P2 — Rev 1.0