LAN9303MI-AKZE Datasheet, PDF (20/386 Pages) SMSC Corporation – Small Form Factor Three Port 10/100 Managed Ethernet Switch with Dual MII/RMII/Turbo MII

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Dual MII/RMII/Turbo MII
Datasheet
2.3.3
Ethernet
Magnetics
LAN9303M/
LAN9303Mi
I²C EEPROM/
I²C
I²C slave
MII
MII
MIIM/
SMI
EEPROM
(optional)
10/100
PHY
Figure 2.2 MII MAC Mode
PHY Mode
Both Port 0 and Port 1 can be configured independently into PHY mode. PHY mode utilizes an external
MAC to provide a network path for the CPU. PHY mode supports MII and RMII interfaces. The external
MII/RMII pins must be connected to an external MAC, providing a communication path to the Switch
Fabric. MII PHY mode can operate at 10, 100, or 200Mbps (Turbo mode). RMII PHY mode can operate
at 10 or 100Mbps. In PHY mode, the device may be SMI managed or I²C managed as detailed in
Section 2.3.4, "Management Modes".
When an EEPROM is connected, the EEPROM loader can be used to load the initial device
configuration from the external EEPROM via the I²C interface. Once operational, if managed, the CPU
can use the I²C interface to read or write the EEPROM.
LAN9303M/
LAN9303Mi
I²C EEPROM/
I²C
I²C slave
EEPROM
(optional)
MIIM/
MII
SMI
MII
10/100
MAC
LAN9303M/
LAN9303Mi
I²C EEPROM/
I²C
I²C slave
RMII
MIIM/
SMI
RMII
EEPROM
(optional)
10/100
MAC
Figure 2.3 MII/RMII PHY Mode
2.3.4
Management Modes
Various modes of management are provided in both MAC and PHY modes of operation. Two separate
interfaces may be used for management: the I²C interface or the SMI/MIIM (Media Independent
Interface Management) slave interface.
The I²C interface runs as an I²C slave. The slave mode is used as a register access path for an
external CPU. The I²C slave and I²C master EEPROM interface are shared interfaces.
Revision 1.5 (07-08-11)
20
DATASHEET
SMSC LAN9303M/LAN9303Mi