|
HD6433832S Datasheet, PDF (209/560 Pages) Renesas Technology Corp – single-chip microcomputers | |||
|
◁ |
9.4.4 Timer C Operation States
Table 9.10 summarizes the timer C operation states.
Table 9.10 Timer C Operation States
Operation Mode Reset Active Sleep
Watch
Sub-
active
Sub-
sleep
Standby
TCC Interval
Reset Functions Functions Halted
Functions/ Functions/ Halted
Halted* Halted*
TCC Auto reload Reset Functions Functions Halted
Functions/ Functions/ Halted
Halted* Halted*
TMC
Reset Functions Retained Retained Functions Retained Retained
Note:
When ÏW/4 is selected as the internal clock of TCC in active mode or sleep mode, the
internal clock is not synchronous with the system clock, so it is synchronized by a
synchronizing circuit. This may result in a maximum error of 1/Ï (s) in the count cycle.
* When timer C is operated in subactive mode or subsleep mode, either an external clock
or the ÏW/4 internal clock must be selected. The counter will not operate in these modes if
another clock is selected. If the internal ÏW/4 clock is selected when ÏW/8 is being used as
the subclock ÏSUB, the lower 2 bits of the counter will operate on the same cycle, with the
least significant bit not being counted.
9.5 Timer F
9.5.1 Overview
Timer F is a 16-bit timer with an output compare function. Compare match signals can be used to
reset the counter, request an interrupt, or toggle the output. Timer F can also be used for external
event counting, and can operate as two independent 8-bit timers, timer FH and timer FL.
Features
Features of timer F are given below.
⢠Choice of four internal clock sources (Ï/32, Ï/16, Ï/4, Ï/2) or an external clock (can be used as
an external event counter).
⢠Output from pin TMOFH is toggled by one compare match signal (the initial value of the
toggle output can be set).
⢠Counter can be reset by the compare match signal.
⢠Two interrupt sources: counter overflow and compare match.
⢠Can operate as two independent 8-bit timers (timer FH and timer FL) in 8-bit mode.
194
|
▷ |