PXB4340E Datasheet, PDF (117/185 Pages) Infineon Technologies AG – ICs for Communications

Bit 24
Bit 23
Bit 22
Bit 21
Bit 20
Bit 19
Bit 18
Bit 17
Bit 16
Bit 15
3;%  (
5HJLVWHU 'HVFULSWLRQ
PRDID2F
1
Indication for a state transition from AIS defect state to AIS
failure state. Set by AOP, reset by the µP. Reported with
interrupt DPSTTR if enabled with PRDIMEN=1 (Dword5).
PAISF2N
1
Indication for a state transition from AIS failure state to AIS
normal state. Set by AOP, reset by the µP. Reported with
interrupt DPSTTR if enabled with PAISMEN=1 (Dword5).
PAISD2F
1
Indication for a state transition from AIS defect state to AIS
failure state. Set by AOP, reset by the µP. Reported with
interrupt DPSTTR if enabled with PAISMEN=1 (Dword5).
PLBS
F4 Loopback State according to I.610. Should be set before inserting a
LB cell, cleared after reception of the looped cell.
Reserved, set to 0.
PSRCIDEN
Loopback of LB Cells using LB source ID:
1
Enabled. Normally this bit is =0 as the location ID is used
to detect intra-domain LB cells.
PLOCIDEN
Loopback of LB Cells using LB location ID
1
Enabled. Normally this bit is =1 as according to the
standard the location ID is used to detect intra-domain LB
cells.
DISF4
0
Enable F4 processing, default.
1
Disable F4 processing. All F4 OAM cells are discarded.
Option selected e.g. at AAL interworking point.
PTSP
0
No F4 Terminating Segment Point.
1
F4 Terminating Segment Point. Do not adjust at F4 OEP.
POSP
0
No F4 Originating Segment Point.
1
F4 Originating Segment Point.
Data Sheet
3-117
04.2000