PXB4340E Datasheet, PDF (105/185 Pages) Infineon Technologies AG – ICs for Communications

3;%  (
5HJLVWHU 'HVFULSWLRQ
 8SVWUHDP ) 2$0 HQWU\ 'ZRUG
Bit 31
Bit 30
Bit 29
Bit 28
Bit 27
Bit 26
Bit 25
Bit 24
Bit 23
PAR
Dword parity protection. In normal operation write to 0. Should always
read as 0.
PPMTEN
Enable a terminating F4 Segment or End-to-End FM flow. Flow type
selected with PMFT in PM RAM entry. Related identifier PPMTID in
Dword6.
PPMOEN
Enable an originating F4 Segment or End-to-End FM flow. Flow type
selected with PMFT in PM RAM entry. Related identifier PPMOID in
Dword6.
Initialize to 0 at a connection setup. Do not change by µP in normal
operation.
PLOCF2N
1
Indication for a state transition from LOC failure state to
LOC normal state. Set by AOP, must be cleared by the µP.
Reported with interrupt UPSTTR if enabled with
PCCMEN=1 in Dword5.
PLOCD2F
1
Indication for a state transition from LOC defect to LOC
failure state. Set by AOP, must be cleared by the µP.
Reported with interrupt UPSTTR if enabled with
PCCMEN=1 in Dword5.
PRDIF2N
1
Indication for a state transition from AIS failure to AIS
normal state. Set by AOP, must be cleared by the µP.
Reported with interrupt UPSTTR if enabled with
PRDIMEN=1 in Dword5.
PRDID2F
1
Indication for a state transition from AIS defect to AIS
failure state. Set by AOP, must be cleared by the µP.
Reported with interrupt UPSTTR if enabled with
PRDIMEN=1 in Dword5.
PAISF2N
1
Indication for a state transition from AIS failure to AIS
normal state. Set by AOP, must be cleared by the µP.
Reported with interrupt UPSTTR if enabled with
PAISMEN=1 in Dword5.
Data Sheet
3-105
04.2000