MC9S12C128V1 Datasheet, PDF (527/690 Pages) Freescale Semiconductor, Inc – MC9S12C Family MC9S12GC Family Reference Manual

Chapter 18 32 Kbyte Flash Module (S12FTS32KV1)
18.4.1.3.2 Program Command
The program operation will program a previously erased word in the Flash array using an embedded
algorithm.
An example flow to execute the program operation is shown in Figure 18-23. The program command write
sequence is as follows:
1. Write to a Flash array address to start the command write sequence for the program command. The
data written will be programmed to the Flash array address written.
2. Write the program command, 0x20, to the FCMD register.
3. Clear the CBEIF flag in the FSTAT register by writing a 1 to CBEIF to launch the program
command.
If a word to be programmed is in a protected area of the Flash array, the PVIOL flag in the FSTAT register
will set and the program command will not launch. Once the program command has successfully launched,
the CCIF flag in the FSTAT register will set after the program operation has completed unless a new
command write sequence has been buffered. By executing a new program command write sequence on
sequential words after the CBEIF flag in the FSTAT register has been set, up to 55% faster programming
time per word can be effectively achieved than by waiting for the CCIF flag to set after each program
operation.
Freescale Semiconductor
MC9S12C-Family / MC9S12GC-Family
527
Rev 01.24