MC9S12C128V1 Datasheet, PDF (232/690 Pages) Freescale Semiconductor, Inc – MC9S12C Family MC9S12GC Family Reference Manual

Chapter 8 Analog-to-Digital Converter (ATD10B8C) Block Description
Field
1
ASCIE
0
ASCIF
Table 8-1. ATDCTL2 Field Descriptions (continued)
Description
ATD Sequence Complete Interrupt Enable
0 ATD Sequence Complete interrupt requests are disabled.
1 ATD Interrupt will be requested whenever ASCIF = 1 is set.
ATD Sequence Complete Interrupt Flag — If ASCIE = 1 the ASCIF flag equals the SCF flag (see
Section 8.3.2.7, “ATD Status Register 0 (ATDSTAT0)”), else ASCIF reads zero. Writes have no effect.
0 No ATD interrupt occurred
1 ATD sequence complete interrupt pending
Table 8-2. External Trigger Configurations
ETRIGLE
0
0
1
1
ETRIGP
0
1
0
1
External Trigger Sensitivity
Falling edge
Rising edge
Low level
High level
8.3.2.4 ATD Control Register 3 (ATDCTL3)
This register controls the conversion sequence length, FIFO for results registers and behavior in Freeze
Mode. Writes to this register will abort current conversion sequence but will not start a new sequence.
Module Base + 0x0003
7
R
0
W
6
S8C
5
S4C
4
S2C
3
S1C
2
FIFO
Reset
0
0
1
0
0
0
= Unimplemented or Reserved
Figure 8-6. ATD Control Register 3 (ATDCTL3)
1
FRZ1
0
0
FRZ0
0
Read: Anytime
Write: Anytime
Table 8-3. ATDCTL3 Field Descriptions
Field
Description
6–3
Conversion Sequence Length — These bits control the number of conversions per sequence. Table 8-4 shows
S8C, S4C, all combinations. At reset, S4C is set to 1 (sequence length is 4). This is to maintain software continuity to HC12
S2C, S1C Family.
232
MC9S12C-Family / MC9S12GC-Family
Freescale Semiconductor
Rev 01.24