LM3S5G51 Datasheet, PDF (39/1266 Pages) Texas Instruments – Stellaris® LM3S5G51 Microcontroller

Stellaris^® LM3S5G51 Microcontroller
Table 1. Revision History (continued)
Date
July 2011
Revision Description
9970 ■ Corrected "Reset Sources" table.
■ Added Important Note that RCC register must be written before RCC2 register.
■ Added missing Start Calibration (CAL) bit to the Precision Internal Oscillator Calibration
(PIOSCCAL) register.
■ Added missing Precision Internal Oscillator Statistics (PIOSCSTAT) register.
■ In Hibernation Module chapter, deleted section "Special Considerations When Using a 4.194304-MHz
Crystal" as this content was added to the errata document.
■ Added a note that all GPIO signals are 5-V tolerant when configured as inputs except for PB0 and
PB1, which are limited to 3.6 V.
■ Corrected LIN Mode bit names in UART Interrupt Clear (UARTICR) register.
■ Corrected pin number for RST in table "Connections for Unused Signals" (other pin tables were
correct).
■ In the "Operating Characteristics" chapter:
– In the "Thermal Characteristics" table, the Thermal resistance value was changed.
– In the "ESD Absolute Maximum Ratings" table, the V_ESDCDM parameter was changed and the
V_ESDMM parameter was deleted.
■ The "Electrical Characteristics" chapter was reorganized by module. In addition, some of the
Recommended DC Operating Conditions, LDO Regulator, Clock, GPIO, Hibernation Module, ADC,
and SSI characteristics were finalized.
■ Additional minor data sheet clarifications and corrections.
March 2011
9538 Started tracking revision history.
January 23, 2012
39
Texas Instruments-Production Data