GXLV Datasheet, PDF (33/247 Pages) National Semiconductor (TI) – Geode™ GXLV Processor Series Low Power Integrated x86 Solutions

Signal Definitions (Continued)
2.2.2 PCI Interface Signals
Signal Name
BGA
Pin No.
FRAME#
A8
(PU)
SPGA
Pin No
C13
(PU)
IRDY#
C9
(PU)
D14
(PU)
TRDY#
B9
(PU)
B14
(PU)
STOP#
C11
(PU)
A15
(PU)
Type
s/t/s
s/t/s
s/t/s
s/t/s
Description
Frame
FRAME# is driven by the current master to indicate the begin-
ning and duration of an access. FRAME# is asserted to indicate
a bus transaction is beginning. While FRAME# is asserted, data
transfers continue. When FRAME# is deasserted, the transac-
tion is in the final data phase.
This pin is internally connected to a weak (>20-kohm) pull-up
resistor.
Initiator Ready
IRDY# is asserted to indicate that the bus master is able to com-
plete the current data phase of the transaction. IRDY# is used in
conjunction with TRDY#. A data phase is completed on any
SYSCLK in which both IRDY# and TRDY# are sampled
asserted. During a write, IRDY# indicates valid data is present
on AD[31:0]. During a read, it indicates the master is prepared to
accept data. Wait cycles are inserted until both IRDY# and
TRDY# are asserted together.
This pin is internally connected to a weak (>20-kohm) pull-up
resistor.
Target Ready
TRDY# is asserted to indicate that the target agent is able to
complete the current data phase of the transaction. TRDY# is
used in conjunction with IRDY#. A data phase is complete on any
SYSCLK in which both TRDY# and IRDY# are sampled
asserted. During a read, TRDY# indicates that valid data is
present on AD[31:0]. During a write, it indicates the target is pre-
pared to accept data. Wait cycles are inserted until both IRDY#
and TRDY# are asserted together.
This pin is internally connected to a weak (>20-kohm) pull-up
resistor.
Target Stop
STOP# is asserted to indicate that the current target is request-
ing the master to stop the current transaction. This signal is used
with DEVSEL# to indicate retry, disconnect or target abort. If
STOP# is sampled active while a master, FRAME# will be deas-
serted and the cycle will be stopped within three SYSCLKs.
STOP# can be asserted in the following cases:
• A PCI master tries to access memory that has been locked by
another master. This condition is detected if FRAME# and
LOCK# are asserted during an address phase.
• The PCI write buffers are full or a previously buffered cycle
has not completed.
• Read cycles that cross cache line boundaries. This is condi-
tional based upon the programming of bit 1 in the PCI Control
Function 2 Register.
This pin is internally connected to a weak (>20-kohm) pull-up
resistor.
Revision 1.1
33
www.national.com