MC68HC908LJ24 Datasheet, PDF (269/464 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
Infrared Serial Communications Interface Module (IRSCI)
I/O Registers
13.11.1 SCI Control Register 1
SCI control register 1:
• Enables loop mode operation
• Enables the SCI
• Controls output polarity
• Controls character length
• Controls SCI wakeup method
• Controls idle character detection
• Enables parity function
• Controls parity type
Address: $0013
Bit 7
6
5
4
3
2
1
Bit 0
Read:
0
LOOPS ENSCI
Write:
M
WAKE ILTY
PEN
PTY
Reset: 0
0
0
0
0
0
0
0
Figure 13-12. SCI Control Register 1 (SCC1)
LOOPS — Loop Mode Select Bit
This read/write bit enables loop mode operation for the SCI only. In
loop mode the RxD pin is disconnected from the SCI, and the
transmitter output goes into the receiver input. Both the transmitter
and the receiver must be enabled to use loop mode. The infrared
encoder/decoder is not in the loop. Reset clears the LOOPS bit.
1 = Loop mode enabled
0 = Normal operation enabled
ENSCI — Enable SCI Bit
This read/write bit enables the SCI and the SCI baud rate generator.
Clearing ENSCI sets the SCTE and TC bits in SCI status register 1
and disables transmitter interrupts. Reset clears the ENSCI bit.
1 = SCI enabled
0 = SCI disabled
MC68HC908LJ24/LK24 — Rev. 2
MOTOROLA
Infrared Serial Communications Interface Module (IRSCI)
For More Information On This Product,
Go to: www.freescale.com
Data Sheet
269