MC68HC908LJ24 Datasheet, PDF (160/464 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
System Integration Module (SIM)
9.8.1 SIM Break Status Register
The SIM break status register (SBSR) contains a flag to indicate that a
break caused an exit from stop mode or wait mode.
Address: $FE00
Bit 7
6
5
4
3
2
1
Bit 0
Read:
SBSW
R
R
R
R
R
R
R
Write:
Note
Reset:
0
Note: Writing a logic 0 clears SBSW.
R = Reserved
Figure 9-20. SIM Break Status Register (SBSR)
SBSW — Break Wait Bit
This status bit is set when a break interrupt causes an exit from wait
mode or stop mode. Clear SBSW by writing a logic 0 to it. Reset clears
SBSW.
1 = Stop mode or wait mode was exited by break interrupt
0 = Stop mode or wait mode was not exited by break interrupt
SBSW can be read within the break interrupt routine. The user can
modify the return address on the stack by subtracting 1 from it. The
following code is an example.
This code works if the H register has been pushed onto the stack in the break
service routine software. This code should be executed at the end of the break
service routine software.
HIBYTE EQU
LOBYTE EQU
If not SBSW, do RTI
BRCLR SBSW,SBSR, RETURN
;See if wait mode or stop mode was exited by
;break.
TST
LOBYTE,SP
;If RETURNLO is not zero,
BNE
DOLO
;then just decrement low byte.
DEC
HIBYTE,SP
;Else deal with high byte, too.
DOLO
DEC
LOBYTE,SP
;Point to WAIT/STOP opcode.
RETURN PULH
RTI
;Restore H register.
Data Sheet
160
MC68HC908LJ24/LK24 — Rev. 2
System Integration Module (SIM)
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA