MC68HC908GT16_07 Datasheet, PDF (98/292 Pages) Freescale Semiconductor, Inc – Microcontrollers

Internal Clock Generator (ICG) Module)
7.7.1 ICG Control Register
The ICG control register (ICGCR) contains the control and status bits for the internal clock generator,
external clock generator, and clock monitor as well as the clock select and interrupt enable bits.
Address: $0036
Bit 7
6
5
4
3
Read:
CMF
CMIE
Write:
0⁽¹⁾
CMON
CS
ICGON
Reset:
0
0
0
0
1
1. See CMF bit description for method of clearing CMF bit.
2
ICGS
0
1
ECGON
0
Bit 0
ECGS
0
= Unimplemented
Figure 7-12. ICG Control Register (ICGCR)
CMIE — Clock Monitor Interrupt Enable Bit
This read/write bit enables clock monitor interrupts. An interrupt will occur when both CMIE and CMF
are set. CMIE can be set when the CMON bit has been set for at least one cycle. CMIE is forced clear
when CMON is clear or during reset.
1 = Clock monitor interrupts enabled
0 = Clock monitor interrupts disabled
CMF — Clock Monitor Interrupt Flag
This read-only bit is set when the clock monitor determines that either ICLK or ECLK becomes inactive
and the CMON bit is set. This bit is cleared by first reading the bit while it is set, followed by writing the
bit low. This bit is forced clear when CMON is clear or during reset.
1 = Either ICLK or ECLK has become inactive.
0 = ICLK and ECLK have not become inactive since the last read of the ICGCR, or the clock monitor
is disabled.
CMON — Clock Monitor On Bit
This read/write bit enables the clock monitor. CMON can be set when both ICLK and ECLK have been
on and stable for at least one bus cycle. (ICGON, ECGON, ICGS, and ECGS are all set.) CMON is
forced set when CMF is set, to avoid inadvertent clearing of CMF. CMON is forced clear when either
ICGON or ECGON is clear, during stop mode with OSCENINSTOP low, or during reset.
1 = Clock monitor output enabled
0 = Clock monitor output disabled
CS — Clock Select Bit
This read/write bit determines which clock will generate the oscillator output clock (CGMXCLK). This
bit can be set when ECGON and ECGS have been set for at least one bus cycle and can be cleared
when ICGON and ICGS have been set for at least one bus cycle. This bit is forced set when the clock
monitor determines the internal clock (ICLK) is inactive or when ICGON is clear. This bit is forced clear
when the clock monitor determines that the external clock (ECLK) is inactive, when ECGON is clear,
or during reset.
1 = External clock (ECLK) sources CGMXCLK
0 = Internal clock (ICLK) sources CGMXCLK
MC68HC908GT16 • MC68HC908GT8 • MC68HC08GT16 Data Sheet, Rev. 5.0
98
Freescale Semiconductor