|
MC68HC908GT16_07 Datasheet, PDF (22/292 Pages) Freescale Semiconductor, Inc – Microcontrollers | |||
|
◁ |
General Description
⢠System protection features:
â Optional computer operating properly (COP) reset
â Low-voltage detection with optional reset and selectable trip points for 3.0-V and 5.0-V
operation
â Illegal opcode detection with reset
â Illegal address detection with reset
⢠Low-power design; fully static with stop and wait modes
⢠Standard low-power modes of operation:
â Wait mode
â Stop mode
⢠Master reset pin and power-on reset (POR)
⢠16 Kbytes of on-chip 100k cycle write/erase capable Flash memory (8 Kbytes on
MC68HC908GT8)
⢠512 bytes of on-chip random-access memory (RAM)
⢠720 bytes of Flash programming routines ROM
⢠Serial peripheral interface module (SPI)
⢠Serial communications interface module (SCI)
⢠Two 16-bit, 2-channel timer interface modules (TIM1 and TIM2) with selectable input capture,
output compare, and pulse-width modulation (PWM) capability on each channel
⢠8-channel, 8-bit successive approximation analog-to-digital converter (ADC)
⢠Break module (BRK) to allow single breakpoint setting during in-circuit debugging
⢠Internal pullups on IRQ and RST to reduce customer system cost
⢠Up to 36 general-purpose input/output (I/O) pins, including:
â 28 shared-function I/O pins
â Six or eight dedicated I/O pins, depending on package choice
⢠Selectable pullups on inputs only on ports A, C, and D. Selection is on an individual port bit basis.
During output mode, pullups are disengaged.
⢠High current 10-mA sink/10-mA source capability on all port pins
⢠Higher current 20-mA sink/source capability on PTC0âPTC4
⢠Timebase module with clock prescaler circuitry for eight user selectable periodic real-time
interrupts with optional active clock source during stop mode for periodic wakeup from stop using
an external 32-kHz crystal or internal oscillator
⢠User selection of having the oscillator enabled or disabled during stop mode
⢠8-bit keyboard wakeup port
⢠Available packages:
â 42-pin shrink dual in-line package (SDIP)
â 44-pin quad flat pack (QFP)
⢠Specific features of the MC68HC908GT16 in 42-pin SDIP are:
â Port C is only 5 bits: PTC0âPTC4
â Port D is 8 bits: PTD0âPTD7; dual 2-channel TIM modules
⢠Specific features of the MC68HC908GT16 in 44-pin QFP are:
â Port C is 7 bits: PTC0âPTC6
â Port D is 8 bits: PTD0âPTD7; dual 2-channel TIM modules
MC68HC908GT16 ⢠MC68HC908GT8 ⢠MC68HC08GT16 Data Sheet, Rev. 5.0
22
Freescale Semiconductor
|
▷ |