MC68HC908GT16_07 Datasheet, PDF (140/292 Pages) Freescale Semiconductor, Inc – Microcontrollers

Resets and Interrupts
Address: $FE01
Bit 7
6
5
4
3
2
1
Bit 0
Read: POR
PIN
COP
ILOP
ILAD MODRST LVI
0
Write:
POR: 1
0
0
0
0
0
0
0
= Unimplemented
Figure 13-3. SIM Reset Status Register (SRSR)
POR — Power-On Reset Flag
1 = Power-on reset since last read of SRSR
0 = Read of SRSR since last power-on reset
PIN — External Reset Flag
1 = External reset via RST pin since last read of SRSR
0 = POR or read of SRSR since last external reset
COP — Computer Operating Properly Reset Bit
1 = Last reset caused by timeout of COP counter
0 = POR or read of SRSR since any reset
ILOP — Illegal Opcode Reset Bit
1 = Last reset caused by an illegal opcode
0 = POR or read of SRSR since any reset
ILAD — Illegal Address Reset Bit
1 = Last reset caused by an opcode fetch from an illegal address
0 = POR or read of SRSR since any reset
MODRST — Monitor Mode Entry Module Reset Bit
1 = Last reset caused by forced monitor mode entry.
0 = POR or read of SRSR since any reset
LVI — Low-Voltage Inhibit Reset Bit
1 = Last reset caused by low-power supply voltage
0 = POR or read of SRSR since any reset
13.3 Interrupts
An interrupt temporarily changes the sequence of program execution to respond to a particular event. An
interrupt does not stop the operation of the instruction being executed, but begins when the current
instruction completes its operation.
13.3.1 Effects
An interrupt:
• Saves the CPU registers on the stack. At the end of the interrupt, the RTI instruction recovers the
CPU registers from the stack so that normal processing can resume.
• Sets the interrupt mask (I bit) to prevent additional interrupts. Once an interrupt is latched, no other
interrupt can take precedence, regardless of its priority.
• Loads the program counter with a user-defined vector address
MC68HC908GT16 • MC68HC908GT8 • MC68HC08GT16 Data Sheet, Rev. 5.0
140
Freescale Semiconductor