MC68HC908GT16_07 Datasheet, PDF (188/292 Pages) Freescale Semiconductor, Inc – Microcontrollers

System Integration Module (SIM)
is pending upon exit from the original interrupt service routine, the pending interrupt is serviced before the
LDA instruction is executed.
The LDA opcode is prefetched by both the INT1 and INT2 RTI instructions. However, in the case of the
INT1 RTI prefetch, this is a redundant operation.
NOTE
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
CLI
LDA #$FF
BACKGROUND
ROUTINE
INT1
PSHH
PULH
RTI
INT1 INTERRUPT SERVICE ROUTINE
INT2
PSHH
INT2 INTERRUPT SERVICE ROUTINE
PULH
RTI
Figure 15-11. Interrupt Recognition Example
15.5.1.2 SWI Instruction
The SWI instruction is a non-maskable instruction that causes an interrupt regardless of the state of the
interrupt mask (I bit) in the condition code register.
NOTE
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
15.5.1.3 Interrupt Status Registers
The flags in the interrupt status registers identify maskable interrupt sources. Table 15-3 summarizes the
interrupt sources and the interrupt status register flags that they set. The interrupt status registers can be
useful for debugging.
MC68HC908GT16 • MC68HC908GT8 • MC68HC08GT16 Data Sheet, Rev. 5.0
188
Freescale Semiconductor