MC68HC908GT16_07 Datasheet, PDF (216/292 Pages) Freescale Semiconductor, Inc – Microcontrollers

Serial Peripheral Interface (SPI) Module
SPR1 and SPR0 — SPI Baud Rate Select Bits
In master mode, these read/write bits select one of four baud rates as shown in Table 16-3. SPR1 and
SPR0 have no effect in slave mode. Reset clears SPR1 and SPR0.
Table 16-3. SPI Master Baud Rate Selection
SPR1 and SPR0
00
01
10
11
Baud Rate Divisor (BD)
2
8
32
128
Use this formula to calculate the SPI baud rate:
Baud rate = ^BUSCLK
BD
16.12.3 SPI Data Register
The SPI data register consists of the read-only receive data register and the write-only transmit data
register. Writing to the SPI data register writes data into the transmit data register. Reading the SPI data
register reads data from the receive data register. The transmit data and receive data registers are
separate registers that can contain different values. See Figure 16-2.
Address: $0012
Bit 7
6
Read: R7
R6
Write: T7
T6
Reset:
5
4
3
2
R5
R4
R3
R2
T5
T4
T3
T2
Unaffected by reset
1
Bit 0
R1
R0
T1
T0
Figure 16-16. SPI Data Register (SPDR)
R7–R0/T7–T0 — Receive/Transmit Data Bits
NOTE
Do not use read-modify-write instructions on the SPI data register since the
register read is not the same as the register written.
MC68HC908GT16 • MC68HC908GT8 • MC68HC08GT16 Data Sheet, Rev. 5.0
216
Freescale Semiconductor