MC68HC05JJ6 Datasheet, PDF (73/216 Pages) Freescale Semiconductor, Inc – General Release Specification Microcontrollers

Operating Modes
6.4.1 Stop Mode
The STOP instruction puts the MCU in a mode with the lowest power
consumption and affects the MCU as follows:
• Turns off the CPU clock and all internal clocks by stopping both
the external pin oscillator and the internal low-power oscillator.
The selection of the oscillator by the OM1 and OM2 bits in the
ISCR is not affected. The stopped clocks turn off the COP
watchdog, the core timer, the programmable timer, the analog
subsystem, and the SIOP.
• Removes any pending core timer interrupts by clearing the core
timer interrupt flags (CTOF and RTIF) in the core timer status and
control register (CTSCR)
• Disables any further core timer interrupts by clearing the core
timer interrupt enable bits (CTOFE and RTIE) in the CTSCR
• Removes any pending programmable timer interrupts by clearing
the timer interrupt flags (ICF, OCF, and TOF) in the timer status
register (TSR)
• Disables any further programmable timer interrupts by clearing the
timer interrupt enable bits (ICIE, OCIE, and TOIE) in the timer
control register (TCR)
• Enables external interrupts via the IRQ pin by setting the IRQE bit
in the IRQ status and control register (ISCR). External interrupts
are also enabled via the PA0 through PA3 pins, if the port A
interrupts are enabled by the port A interrupt mask option.
• Enables interrupts in general by clearing the I bit in the condition
code register
The STOP instruction does not affect any other bits, registers, or I/O
lines.
These conditions bring the MCU out of stop mode:
• An external interrupt signal on the IRQ pin — A high-to-low
transition on the IRQ pin loads the program counter with the
contents of locations $1FFA and $1FFB.
MC68HC05JJ6/MC68HC05JP6 — Rev. 3.2
Freescale Semiconductor
Operating Modes
General Release Specification
73